Technical documentation Beocreate REV 2.1 with TPA 3220

Hi All,

I recently have purchased a Beocreate Board REV 2.1 equipped whith 2x  TPA3220 instread of 3x TPA3128 in REV 1.2. The board also has a different layout whith an additional a 3-pin screw terminal and additional jumper selector. The TPA 3220 supports mono parallell bridge mode after LC filter whith up to 155 W peak at 3 ohms (by simply putting INS_P & INS_M to GND). Is the bridge mode supported by the new board layout? Is there any technical documentation available?

GX Hans

1 comment

Please sign in to leave a comment.