0

power control and touch display

Kreuels69

May 17, 2021 09:53

None

Hello,
I would like to connect the power controller and have a question about it. Where can I connect the touch display?
Best wishes
Peter Kreuels

Date Votes

4 comments

0

HiFiBerry team May 17, 2021 10:07

You mean the power supply for the official Pi touchscreen? You could connect it on the output voltage connector of teh power controller if you're using the ribbon cable to the Pi and your NOT using anything that runs higher voltages than 5.1V (e.g. Amp2, Amp100, ...)

Comment actions Permalink
0
Kreuels69 May 17, 2021 10:18
Yes I mean the power supply for the official Pi touchscreen. Thann I´ll do it that way. Thanks a lot!
```
 
```
Comment actions Permalink
1

joerg krebs August 24, 2021 20:57

Hi, I'm running an AMP2. Therefore I cannot use the output voltage as suggested. Any solution?

Comment actions Permalink
0

Martin September 07, 2021 07:40

Hello together, I do have the same hardware setup like joerg has - did anyone already solved this problem and is an according solution available?

Comment actions Permalink

Please sign in to leave a comment.