0

Unable to boot HifiBerry Digi+, new installation

Jussi Hermunen

November 30, 2020 07:48

None

Follow

HI all,

Similar to this post, I am unable to boot my newly acquired RaspberryPi 4 & Digi+ installation. I bought a bundle from the website (incl. power source, SD-card, reader case), so components should be right.

I get a solid red light and a blinking green (four times, repeat on intervals) and no signal from HDMI.

I followed the instructions and flashed the SD-card using Etcher, and can see that the content was written properly. I can try another card if needed. 

Can anyone help me on how to start troubleshooting the issue? 

• Facebook
• Twitter
• LinkedIn

3 comments

• 0
  
  HiFiBerry team November 30, 2020 11:36

  Did you insert teh SD card into the SD card slot or did you connect it with the SD card reader to USB?

• 0
  
  Jussi Hermunen November 30, 2020 12:27

  Bloody hell. Of course I connected it with the card reader to the USB ports in the back, as looking at these rough instructions here made me think the USB key is the way to go. I'm referring to the image with the case assembled and the usb dongle sticking out.

  To clarify, I did now insert the card into the board. Which seems to boot nicely. 

  Thanks a lot for the swift reply, HifiBerry team! 

• 0
  
  HiFiBerry team November 30, 2020 12:28

  Good to hear. We should get a picture without the USB dongle ;-)