Hello.
I want to connect some audio inputs to the DAC+ADC PRO board.
Want to use some pcb type XLR female sockets, like this:
https://eu.mouser.com/ProductDetail/Neutrik/NC3FAH1?qs=jCymNF74TgUeDVE6PPGqug%3D%3D
My question is, do I need some extra circuit for interfacing this with board connector?
All my best.
Iavn.
In general, its possible to directly connect XLR outputs (up to 6Vpp) directly to the DAC+ ADC, e.g. using this sockets.
So seems regular mic with XLR can be connected no problem?
And if I want to use also a stereo pair of 6.5mm jacks (MONO) , unbalanced ones?
Just make sure your Mic doesn't require phantom power as this isn't available. Dynamic microphone will work. Mono jacks will just be connected to left or right.
Ok, sounds good.
So for mono jack seems I only need to connect GND and (in R-) or (in L-) together and feed signal to +R / +L , right?