Hi,
if I understand the wiring correctly, for one speaker, the woofers are connected to different outputs; in a stereo setup both woofers from one speaker are sharing an output.
While the stereo setup seems clear, why are you using separate woofer outputs for single-speaker setups?
Thanks, Christian
Hi,
the single speaker setup should also be 2 channel now. Where did you find the information about the other cabling?
Best regards,
Daniel
Hi,
so in a 1-speaker-setup the woofers are assigned left and right, and the middle tweeter is just one side?
Thanks, Christian
Hi,
I'm not sure what you mean. In a one-speaker setup, you will only use 2 of the 4 channels.
Best regards,
Daniel
Hi Daniel,
if you on your website click your way through to the CX100 build guide and click print to get the pdf, it's on page 16 clear that 3 channels are used in a one-speaker setup. One for the bottom woofer, one for the top woofer and a third for the tweeter. Your guide's link: https://www.hifiberry.com/wp-content/uploads/2018/01/cx100-guide.compressed-3.pdf
In the stereo guide, which I only found by googling it (why isn't there a link on the hifiberry/beocreate page with the other 3 guides?), has a different approch to wireing on page 9. Here the top and bottom woofers on each speaker share the same channel. See: https://www.hifiberry.com/wp-content/uploads/2018/04/cx100_Stereo-guide.pdf
best regards,
Viktor Perselli
Note that the colors on the wires for the tweeters (purple and white) in the stereo-guide are reversed compared to the single speaker setup guide. I guess the single speakers setup is the correct one when it comes to polarity.
Thanks for posting links to the guide. It seems this thread is the only way to find them!