Hi Daniel,
I'm referring to the great guide for the DSP board in asking how I can do the same for the Beta board. How can I feed the new REW-measures for the Beta board into my existing two-channel filter and how I can copy it into the Beta's EEPROM?
Thank you,
Tomislav
Hi,
I'm not sure what exactly is the issue. DSPToolkit works the same on the DAC+ DSP as on the Beocreate.
Best regards,
Daniel
Could you perhaps point me to a resource where this is explaiend for the Beocreate? I checked the Beocreate Documentation, but didn't find what I'm looking for. I'm not using Sigmastudio but run the REW software directly on the pi (via vnc) and would like to push the filters via commandline directly to the EEPROM. Since I want to use the Beta board, I can't just use the command outlined in the REW BASICS documentation (dsptoolkit apply-rew-filters filters.txt). So I'm wondering where to copy the filters to.
Thank you,
Tomislav
Hi,
this is the same on the Beocreate as on the DSP board. First you need to install the dsptoolkit software, then apply a profile that supports the necessary filters and last apply these.
Best regards,
Daniel
