0

no load (loudspeaker) plugged on the output

I just read an answer to a similar post, but I want to be more specific and therefor certain.

If I use an AMP2 or Beocreate 4-channel amplifier, but I do not use all the channels, should I end the unused outputs with an 8 or 16 ohm resistor or can I leave them without a load?

Can they die without? Otherwise, Is better or useless or dangerous a end resistance?

However, no signal would be sent to the unused channels ..

Thank you

Best Regards,

Flavio.

1 comment

Please sign in to leave a comment.