Good evening everyone, I have a question for a school project and I was wondering if any of you have the knowledge to answer me? The situation: I intend to use a Raspberry Pi 3 and adding thereto a module (+ amp HifiBerry: https://www.hifiberry.com/ampplus/). Unfortunately for me, it uses all the GPIO ports Raspberry Pi 3. Why is this a problem? Because I would use a thermal sensor (http://fr.farnell.com/panasonic-ew/amn34111j/capteur-motion-10m-110-93-noir/dp/1373716) that uses GPIO 7 of the P1 port.
I know that the amp + does not use the GPIO 7. Is it possible to weld it to include my module on? Thank you for your answers