Hi!
I've attached some i2c stuff on my pi, so the pins: SDA,SCL, 5V, GND and PIN 18 (IR)
are used.
Now the Questions :
1. Does the HifiBerry block the usage any of these PINS?
2. Which Hifiberry DAC (DIY) should i buy? so that the "top" of the hifiberry has the pins to attach my own connector?
I would like to use the two CHINCH Outputs the HifiBerry provides.
Kind regards
Tropico
Date
Votes
2 comments
-
HiFiBerry team None of the P1 pins are used. You need to buy the version without the Raspberry Pi connectors. Mounting it from the bottom by just connection the P5 header is possible. But using the Cinch connectors then would need mounting them also from the bottom of the board.
Best regards
Daniel -
tropicthunder Hello Daniel,
thank you for your support.
that sounds very good :) So I will only attach the P5 Header + Chinch connectors.
Why do I need to put the Connectors on the bottom and not the top?
(Custom Case is large enough for both)
Kind Regards
Tropico
Please sign in to leave a comment.