0

Hifiberry amp and Pi musicbox 0.6

After a little trial and error these are the settings that worked for me.
You have to make some manual changes to Settings.ini in the config folder. (Just put your sd card in the computer)
It was not possible to get it working changing settings in the web interface. After reboot I could not acces the web interface anymore.
Now i have hardware volume control. Once working this is a very good music player.


# ------------------
# | Audio Settings |
# ------------------
# Because of limitations with some USB-DACs, MusicBox downsamples USB sound to 44k by default. Set to false to disable.
downsample_usb = true

# Set default audio output. This overrides the automatic detection (which sets to usb audio if an usb audio device
# is found, else to hdmi (if hdmi is connected at boot), and otherwise just to the analog out).
# i2s cards (e.g. HifiBerry etc) are not detected automatically and must be explicitly set here.
# Options: analog, hdmi, usb, hifiberry_dac, hifiberry_digi, hifiberry_dacplus, hifiberry_amp, iqaudio_dac
output = hifiberry_amp

[audio]
# Set the startup volume of MusicBox
# Values: from 0 to 100
mixer_volume = 65

# --------------------------------------------------------------------------
# | OTHER Settings |
# | You probably don't want to edit the settings below this line. Really. |
# | Unless you know what you're doing, or you want to change the webclient |
# --------------------------------------------------------------------------
# This sets the gstreamer buffer. It's a bit tricky...
# If you have problems with stuttering sound, try other values here, like:
# or
#output = alsasink buffer-time=300000 latency-time=20000
#output = alsasink buffer-time=200000 latency-time=10000
#output = alsasink

#mixer = software
mixer=alsamixer

# Optionally, you can use alsamixer. This enables you to use hardware mixers of usb/audiocards.
# Set the previous setting to:
#mixer = alsamixer
# And set the card and contol below. E.g.
#card = 1
#control = Master
# Run the command 'amixer scontrols' from the commandline to list available controls on your system
# See https://github.com/mopidy/mopidy-alsamixer
[alsamixer]
card = 1
control = Master

0 comments

Please sign in to leave a comment.