Hi, I have the following setup in my flat:
My speakers in my living room are built into the ceiling and wired into a cupboard. I've built an amp2 and it is powering the speakers and connected to my network via ethernet cable; the amp2 is physically located in the cupboard where the speaker cables terminate.
Now I would like to connect my turntable's output to the amp2; how is this possible?
I was planning to build another hifiberry module with the ADC and place it in my living room connected to the line output of my phono preamp, and connect it to my network via ethernet.
Is this supported by hifiberry OS? i.e. if I build this ADC module will it appear as an input source on the AMP2?
This is a graph of what I'm trying to do; my question is how can I make the link between the ADC and the AMP2 over ethernet.
|
Living Room | Service Cupboard
|
|
|
+-----------+ +-------------+ |
| | Lineout | |Ethernet| +--------------+
|Turntable +-------->|Hifiberry +--------+->| AMP2 |
| | |ADC | ??? | | |
+-----------+ +-------------+ | +------+-------+
| |
| |
| |
| |
+-----------+ | |
|Ceiling | speaker cable | |
|Speakers |<-------------------------------+---------+
| | |
+-----------+ |
|
|
