Hi Daniel,
I connected with 40 pins GPIO my RPI3 with Dac+ Pro used as reclocker, in turn connected to a board Audio Gd i2s output module card that then enters in a dac Denafrips Terminator.
Kindly I would know if is possible to take i2s signal on Dac+ Pro 40 pins GPIO instead of on the i2 header named P4.
Or with this connection (i2s on GPIO) maybe do I take i2s signal directly from RPI3 and not from the reclocker?
Thank you so much.
Claudio
Dear Claudio,
there is no "re-clocking" on the DAC+ Pro - and that's a good thing. Re-clocking is just a very crude workaround if no good clocks are available. Re-clocking basically means to work with 2 different clocks. That's not what we're doing here. The DAC+ Pro locally generates the clocks locally and is master for all clocks.
If you don't need to use an high-frequency master clock, you can also get these signals on the GPIO header. The master-clock (needed by many high-quality DACs) is only available on the I2S header.
Best regards,
Daniel
Thanks Daniel for your competent reply.